<strong>List Of How To Replace A Bathroom Faucet And Drain Ideas</strong>. But most importantly check to make sure your connections are tight. Fit and secure new fixture.
Table of Contents
Table of Contents
Web Push The Tailpiece Upward To Free The Drain Flange.
If the flange won't budge, wiggle the tailpiece until the seal breaks. Wrap both ends of the new nipple with thread tape and screw it into the fitting inside the wall. Start by removing the faucet that’s in place already.
From The Underside Of The Sink Assemble In.
Just let the water run for a little bit to flush out the lines and faucet. Web install the new nipple. Ad we seal and fix your bathroom.
Web Wipe The Valve Stem/Packing Nut Zone Completely Dry And Wrap With Toilet Tissue (Photo 15).
Before connecting the horizontal pivot rod to the vertical. Turn off the water supply. Web install the faucet.
The First Step To Avoid A Flood Is To Turn Off The Water Supply To The Bathroom Sink.
Web place a socket wrench over the bathtub faucet stem until it covers the hex nut. Beneath the sink, use your hand or a pipe wrench to unscrew the connection where the tailpiece enters the drain. Apply a light coating of solder paste or flux to the inside of the valve fittings, and to the cleaned end of the copper pipe.
Web How To Replace A Bathroom Faucet & Drain.
Web clean the copper tubing with fine sandpaper, then slip the nut, compression ring and valve body over the pipe and tighten. Get your bathroom seal today. Remove the faucet and clean the sink.
